World-Designs-Forum  

Go Back   World-Designs-Forum > FAQ > FAQ - Test and Measurement
Register FAQ Members List Calendar Gallery Today's Posts Search Today's Posts Mark Forums Read

FAQ - Test and Measurement Checking Audio Components

 
 
Thread Tools Display Modes
  #1  
Old 6th January 2006, 10:00 PM
FAQ Team FAQ Team is offline
FAQ *****istrator
 
Join Date: Jan 2006
Location: faq
Posts: 44
Default Measuring the level of feedback in an amp

Measuring the level of feedback in an amp

First, measure the input sensitivity of the amplifier with no feedback.

This is the input level of signal needed to drive the amp to full output and is usually done with sine wave at 1KHz. Increase the level from a signal generator into the amp until clipping distortion is just visible on a scope monitoring the amp output. Check the level of the sig gen signal at this point.

Then measure it again with feedback.

The difference, expressed in dB, is the level of feedback.

Using WAD`s 300B PSE as an example,
it has 380mV sensitivity without feedback and 1000mV with, so the level of feedback is determined by;

log(1000mV divided by 380mV) x 20 = 8.4dB
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Kel84 Feedback Wiring Bug BL21DE3 WAD Problems 2 11th September 2006 05:29 PM
partial feedback dave dove Amplifiers 12 12th April 2006 11:07 PM
Feedback fun with K5881 NealG WAD General 15 18th February 2006 12:09 PM
Lowering feedback in KiT88 and KeL34 FAQ Team FAQ - Upgrades and Tweaks 0 6th January 2006 09:25 PM
Lowering feedback in KIT34 KIT6550 KEL84 FAQ Team FAQ - Upgrades and Tweaks 0 6th January 2006 09:22 PM


All times are GMT +1. The time now is 11:21 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright World Designs