View Single Post
  #4  
Old 7th June 2021, 01:40 PM
bob orbell bob orbell is offline
Senior Member
 
Join Date: Nov 2009
Location: kettering northants.
Posts: 2,369
Default Re: KEL34 making safe to work on

If they are present, they will be directly across the capacitor terminals, about 220K, if not use a 100 ohm resistor with two lengths of insulated wire soldered to the resistor and short the capacitors for a few seconds, there may be a small crack as you make contact, but there may be no charge at all in them, you can check with your meter for voltage, anything lower than 50 volts will not be felt. Bob
Reply With Quote