View Single Post
  #22  
Old 17th February 2019, 07:54 PM
G Willis G Willis is offline
Member
 
Join Date: Mar 2017
Location: UK
Posts: 31
Default Re: New build WDPhono 3 Questions; heater voltage/LED

I have now done the following:

1. Replaced all the power resistors so that they are well clear of the board
2. Replaced the regulator and fitted as described by Bob. This was much easier second time around as I fitted it to the chassis but only soldered it to the board when all the other wiring was complete.
3. I rewired all the pins in the PSU ensuring good joints. I now have a good technique for doing this.
4. Redid some of the soldering in the Phono3

The good news is that now the heater is at 6.5v as stated.

Thank you all for your help. I can now set up my record deck.

Graham
Reply With Quote